SEQ'ATEX SET100DP Integrated Pilots version

The SEQ'ATEX SET100DP is an adjustable device for control and full automatization of declogging equipment, whose declogging is done by pressured air injections.

It can perform various functions: unclogging sequence, filter pressure drop measurement, measurement of compressed air pressure, monitoring of dust rejection associated with our CDM dust probe, communication with the external.

Permanent control of differential pressure allows an optimal efficiency according to the whole parameters, for any type of exploitation and product.

The pilots are integrated into the sequencer controller.

Downloads

Commercial notices

Technical notices

Configure my need

Supply voltage

Wanted supply voltage

115 or 230 V AC

24 / 48 V AC

24 V DC

Outputs voltage

Solenoid valves power

Number of outputs ( < or = to 100 )

Tanks compressed air measurement

Quantity

Advantages

Usability of settings on touch screen
Ease and precision of settings
Electrical control of outputs SV command with faults display
Compressed air control by measure or the associated digital input.
Externals controls.
Protection of settings
Calibration of the zero pressure
Counters number of cycles done
Registration of mini and maxi pressure recorded.
Graphical representation of the load loss, compressed air and dust rejection.
Communication with external: MODBUS RTU protocol (gateways available for other protocols)
Communication with a dust rejection controller CDM
Operation possible with SV extension boxes

Controls and settings

Setup by touch screen 4.3 "
Display of the loss of load and alarm levels
Display of the progress of cleaning cycle
Fault reset
Manuel running
multiple layers of protection by passwords for access to the settings
choice of language French / English

Characteristics

Power supply 100-240V AC auto overload protected or 24VDC
SV output voltage: 24V DC - 25W
Maximum pilots : 12
Possibility of obtaining up to 108 pilots with 8 additional SV extension boxes.
DP measure scale 0-500 daPa
4-20mA output for report of the DP measurement
Forced manual run or choice of the SV
Running accelerated by threshold DP
high and low alarm DP
Fan stop detection with number of cycles at stop
Four AON inputs for:
- run order
- compressed air control
- accelerated running
- forced running

Three relay outputs for:
- faults (SV electric fault, compressed air, DP alarms, rejection alarm, communication)
- declogging running response
- High DP alarm
Operating temperature 0 to 55 ° C
Box PC - IP65

According to options:

Compressed air measurement scale: 0-6 bars
4-20mA output for reporting of compressed air measurement
MODBUS RTU communication
Identifier, parity and adjustable speed (from 2400 to 115200 baud)
Gateways available for other protocols: for example PROFIBUS DP
Communication with a CDM dust rejection control.
The CDM power supply is provided in SET100DP + fuse protection (4-wire connection).
Communication with SV extension boxes (2-wire bus)
Up to 8 boxes of 12 pilots. In the SV 24VDC output version, the power supply for the extension boxes is provided in the SET100DP + fuse protection (2 wires).